Make sure the followint boxes are checked: Then for device select the USB to UART driver you have already installed on your Mac. Open the Configure menu and the Rig Control sub-menuĬlick the open button for the Rig description file and select the IC-7300.xml file that you have already downloaded. Hamlib does not have a setting choice for the 7300, so you will need to download one and use it for your RigCAT settings. I tried using the flrig companion program, but found that it would get out of sync with radio and would make unexpected changes to the filters that would persist after quitting the program.īasically, I followed the instructions from WA7EWC fldigi setup again.īefore setting up fldigi, you will need an xml rig definition file. Using RigCat, one can do everything with a single USB connection with no other wires required. Here is what they look like on my machine. Name it something obvious, like "fldigi." Once you have made the changes, save the new configuration to the SD card. I set the power level to 50% for digital modes. I used the settings I found from WA7EWC IC-7300 setup Configure the Icom 7300īefore making any changes, I recommend that you save the existing radio configuration to the SD card, so that if things don't work out you can go back to a known working configuration. ĭownload the driver and run the install package before doing the other steps. Silicon Labs has driver for free download for the Mac at: Ī complete set for drivers for multiple platforms can be found here. A CP210x USB to UART Bridge VCP Driver is needed. The first step step is to get the right driver for your USB port. Icom 7300 fldigi on a Mac laptop Configuring fldigi for the Icom 7300 on a Mac laptop Drivers
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |